Shower diverter valves usually used to swap between a hand-held shower and a standard overhead shower.
Shower diverter valves are basically a knob on a standard bath-tub faucet that facilitates the switch of water from the shower head back to the faucet. A regular operation of such spigots often spoils the movement of the shower valves and results in drippy and leaky faucets.
The removal technique shower diverter valves might look very simple, but it is the most harried part of this process.
The first action to remove the knob isn’t pulling it straight out of the shower diverter valves, instead use a gear puller to do so. Use a gear to pull it out and you are good to go. Once the knob is off, use a wrench to bend the metal tube behind the knob. Later cut the caulk surrounding the metal plate and you will have a good view to the shower diverter. Once that is done, the next is repair the diverter.
After all those possible efforts you applied in removing the knob, the job of replacing it back isn’t that wearisome. Put the shower diverter valves back to its actual position and screw it back in. Using a wrench tighten the diverter valve but make sure you don’t overdo it. Once everything is fixed, fidget a bit with the knob to assure that it properly points down for the bath faucet and (left or up) for the shower faucet.
Learning how to repair shower faucet would only depend upon the kind of problem you’re facing in the bathroom. Replacing a shower diverter with a new one is an ideal solution. You can also opt for a temperature control valve or a pressure based shower diverter valves to save the troublesome bathroom setbacks. Agreed it would cost you a few extra dollars, but it would worthwhile!